Here are the steps to getting Wireguard and the Wireguard UI to run as a standard, non-administrative user on Windows.
Logon
1123 views
You can easily implement a rate limit on interfaces using the following commands.
set traffic-policy limiter RATE-LIMIT-GUEST-5Mset traffic-policy limiter RATE-LIMIT-GUEST-5M description
3419 views
If you receive an error during an apt-get upgrade similar to what's below, use the command below to allow the
2772 views
To enter the non UniFi OS shell and use the full Debian command set:
unifi-os shell
Reboot the UniFi OS without interrupting
5855 views
We recently came across this strange issue when switching static IP providers on a UDM Pro. In the new UI
4148 views
From my article here: https://community.ui.com/questions/IPv6-on-Single-WAN-IPv4-LB-FO-Working-Config/2ed8f836-e02e-4b65-aba1-8a0ebff1e16c
I have residential Spectrum service with native IPv6 via DHCPv6-PD via eth0 and AT&T via eth1
3903 views
Use the following commands to add the necessary components for IPv6 connectivity. This example was taken from an EdgeRouter X
3428 views
Use the following command snippets to add DDNS to EdgeOS for NOIP.
set service dns dynamic interface eth0 service dyndns host-name
2991 views
In our FreePBX installs, we use the following upstream shaper based on DSCP markings. Modify the bandwidth and DSCP marking
8642 views
Enter the following commands in the cli to reset the dynamic IPv6 interface.
release dhcpv6-pd interface eth0delete dhcpv6-pd duidrenew dhcpv6-pd interface
3113 views